HUAWEI AP2010DN Wall Plate AP
Produktet kan p.t. ikke leveres, og er muligvis udgået. Kontakt os venligst for hjælp til at finde et tilsvarende produkt.
|
HUAWEI AP2010DN Wall Plate AP
-
Hastighed
300Mbps
-
Type
Adgangspunkt
|
AP2010DN Wall Plate Access Point
Features:
WLAN features
- Complies with IEEE 802.11a/b/g/n
- Provides a maximum rate of 300 Mbit/s
- Maximum Ratio Combining (MRC)
- Cyclic Shift Diversity (CSD)
- Maximum-Likelihood Detection (MLD)
- Data unit aggregation, including A-MPDU (Tx/Rx) and A-MSDU (Rx only)
- Supports 802.11 Dynamic Frequency Selection (DFS).
- Short GI in 20 MHz and 40 MHz modes.
- Priority mapping and packet scheduling based on a Wi-Fi Multimedia (WMM) profile to implement priority-based data processing and forwarding
- Automatic (Default) and manual rate adjustment
- WLAN channel management and channel rate adjustment
- Automatic channel scanning and interference avoidance
- Service Set Identifier (SSID) hiding
- Signal Sustain Technology (SST)
- Unscheduled Automatic Power Save Delivery (U-APSD)
- Control and Provisioning of Wireless Access Points (CAPWAP)
- Automatic login
- Hotspot 2.0
Network features
- Complies with IEEE 802.3u
- Auto-negotiation of the rate and duplex mode and automatic switchover between the Media Dependent Interface (MDI) and Media Dependent Interface Crossover (MDI-X)
- SSID-based VLAN assignment
- 4,094 VLAN IDs (1-4094) and a maximum of 8 virtual APs (VAPs) for each radio frequency
- AP control channel in tagged and untagged mode
- DHCP client, obtaining IP addresses through DHCP
- Tunnel data forwarding and direct data forwarding
- STA isolation in the same VLAN
- Access Control Lists (ACLs)
- Link Layer Discovery Protocol (LLDP)
- Uninterrupted service forwarding upon CAPWAP channel disconnection
- Unified authentication on the AC
- AC dual-link backup and VRRP hot backup
- Native IPv6
- IPv4/IPv6 dual stack
- IPv6 Portal
- IPv6 SAVI
- IPv4/IPv6 ACL
- Soft GRE
QoS features
- Priority mapping and packet scheduling based on a WiFi Multimedia (WMM) profile to implement priority-based data processing and forwarding
- WMM parameter management for each radio frequency
- WMM power saving
- Priority mapping for upstream packets and flow-based mapping for downstream packets
- Queue mapping and scheduling
- User-based bandwidth limiting
- Adaptive bandwidth management based on the number of users and radio environment to improve user experience
Security features
- Open system authentication
- WEP authentication/encryption
- WPA/WPA2-PSK authentication and encryption
- WPA/WPA2-802.1x authentication and encryption
- WAPI authentication and encryption
- Supports Wireless Intrusion Detection System (WIDS), including:
- Rogue AP and STA detection
- Attack detection
- STA/AP blacklist and whitelist
- .DHCP snooping
- Dynamic ARP Inspection (DAI)
- IP Source Guard (IPSG)
- Protected Management Frame (PMF)
Maintenance features
- Unified management and maintenance on the AC
- Automatic login and configuration loading plus Plug-and-Play (PnP)
- Batch upgrade
- Local AP management using Telnet
- Real-time configuration monitoring and fast fault location using the NMS
- System status alarm
BYOD
- Identifies the device type according to the Organizationally Unique Identifier (OUI) in the MAC address
- Identifies the device type according to the User Agent (UA) information in an HTTP packet
- Identifies the device type according to DHCP options
- The RADIUS server delivers packet forwarding, security, and QoS policies according to the device type carried in the RADIUS authentication and accounting packets
Spectrum analysis
- Identifies interference sources, including:
- Bluetooth devices
- Microwave ovens
- Cordless phones
- ZigBees
- Game controllers
- 2.4 GHz/5 GHz wireless video and audio devices
- Baby monitors
- .Works with Huawei eSight to locate and perform spectrum analysis on interference sources
Specifications
Items |
Specifications |
Technical Specifications |
Dimensions (H x W x D) |
1.7 in. x 3.3 in. x 3.3 in. (45 mm x 86 mm x 86 mm) |
Weight |
≤ 0.4 lb. (0.2 kg) |
System memory |
128 MB |
Power Specifications |
Power input |
PoE power: PoE function complies with IEEE 802.3af and 802.3at |
Maximum power consumption |
5.5W
Note: Maximum power consumption depends on local laws |
Environment Parameters |
Operating temperature |
32oF to 104oF (0oC to 40oC) |
Storage temperature |
-40oF to 158oF (-40oC to 70oC) |
Humidity |
5% to 95% (Non-condensing) |
Altitude |
-196.8 ft. to 16,404.1 ft. (-60m to 5,000m) |
Atmospheric pressure |
20.6 inHg to 31.3 inHg (70 kPa to 106 kPa) |
Radio
Items |
Specifications |
Antenna Type |
Built-in |
Antenna Gain |
- 2.4 GHz: 2 dBi
- 5 GHz: 2.5 dBi
|
Maximum Number of Concurrent Users |
≤ 128 |
Maximum Transmit Power for Each Radio Frequency |
- 2.4 GHz: 16 dBm
- 5 GHz: 14 dBm
Note: Actual transmit power depends on local laws and regulations. The AP2010DN uses a 86-type box and applies only to countries and regions that support 86-type boxes
You can adjust the transmit power from maximum to 1 dBm in 1 dB increments. |
Maximum Number of Non-overlapping Channels |
2.4 GHz
802.11b/g
20 MHz: 3
802.11n
|
5 GHz
802.11a
20 MHz: 5
802.11n
|
Note: This table uses the number of non-overlapping channels supported by China as an example. The number of non-overlapping channels varies in different countries. For details, see the Country Code & Channels compliance status |
Channel Rates |
- 802.11b: 1, 2, 5.5, and 11 Mbit/s
- 802.11a/g: 6, 9, 12, 18, 24, 36, 48, and 54 Mbit/s
- 802.11n: 6.5 to 300 Mbit/s
|
Receiver Sensitivity |
2.4 GHz
802.11b (CCK)
- -89 dBm @ 1 Mb/s
- -88 dBm @ 2 Mb/s
- -88 dBm @ 5.5 Mb/s
- -87 dBm @ 11 Mb/s
|
2.4 GHz
802.11g (Non-HT20)
- -88 dBm @ 6 Mb/s
- -85 dBm @ 9 Mb/s
- -85 dBm @ 12 Mb/s
- -84 dBm @ 18 Mb/s
- -81 dBm @ 24 Mb/s
- -78 dBm @ 36 Mb/s
- -74 dBm @ 48 Mb/s
- -71 dBm @
- 54 Mb/s
|
2.4 GHz
802.11n (HT20)
- -88 dBm @ MCS0
- -85 dBm @ MCS1
- -84 dBm @ MCS2
- -81 dBm @ MCS3
- -77 dBm @ MCS4
- -74 dBm @ MCS5
- -72 dBm @ MCS6
- -69 dBm @ MCS7
|
2.4 GHz
802.11n (HT40)
- -88 dBm @ MCS0
- -84 dBm @ MCS1
- -82 dBm @ MCS2
- -77 dBm @ MCS3
- -74 dBm @ MCS4
- -71 dBm @ MCS5
- -70 dBm @ MCS6
- -69 dBm @ MCS7
|
-- |
5 GHz
802.11a (Non-HT20)
- -88 dBm @ 6 Mb/s
- -87 dBm @ 9 Mb/s
- -86 dBm @ 12 Mb/s
- -83 dBm @ 18 Mb/s
- -80 dBm @ 24 Mb/s
- -77 dBm @ 36 Mb/s
- -72 dBm @ 48 Mb/s
- -71 dBm @ 54 Mb/s
|
5 GHz
802.11n (HT20)
- -88 dBm @ MCS0
- -85 dBm @ MCS1
- -83 dBm @ MCS2
- -78 dBm @ MCS3
- -75 dBm @ MCS4
- -71 dBm @ MCS5
- -70 dBm @ MCS6
- -69 dBm @ MCS7
|
5 GHz
802.11n (HT40)
- -87 dBm @ MCS0
- -84 dBm @ MCS1
- -81 dBm @ MCS2
- -78 dBm @ MCS3
- -74 dBm @ MCS4
- -71 dBm @ MCS5
- -69 dBm @ MCS6
- -68 dBm @ MCS7
|
Selvom vi gør vort bedste for at give fyldestgørende information, så er billederne kun vejledende, og selve varen er ikke nødvendigvis 100% identisk med det viste billede. Produkter kan være vist med ekstraudstyr der ikke er inkluderet eller i andre form- og farvevarianter. Hvis der er forskel mellem produktoverskrift, beskrivelse og billede, så er det produktoverskriften som gælder. Hvis du er i tvivl, så kontakt os gerne. Vi tager forbehold for trykfejl, ændring af priser og specifikationer uden varsel.